How To Fix The Print Lean On Canon

We want to print a document, the paper was always skewed, and not interested in all. Or even do not want to withdraw the paper, only rollernya muter2 aja ..
This problem is most likely due to foreign objects get into the paper tray or maybe even get into the engine (ga tau real name part, just inside the printer is ...). Trus gimana dong .. OK, straight to the scene ...
For a paper that has always pulled him sideways, or want to come in part, then hours ...

1. Unloading your printer
2. Check at the bottom of the puller roller paper (from end to end it).
3. Are there any foreign objects (dirt, paper clips, coins, pencils, dead insects, or anything else)
4. If a hard look at or check, all the springs off the retaining roller (What's really name?)
5. Usually the foreign object is pinched, clean / dispose of objects that are stuck.
6. Replace the spring and the other, the printer is installed before the test covers.

For printers that do not want to pull the paper at all:

1. Unloading your printer.
2. In the mechanical printer (usually a set, which is located under the roller and the paper tray) there is one couple in which there is a spring wheel.
3. Usually the wheel is separated from its seat (held by a needle-like long irons).
4. If the wheel is cuman off, you simply put back.
5. But when the spring (inside) wheel is damaged, usually susuananya messy, it's not round at all.
6. You can cut pegasnya maximum of 50% of the existing spring.
7. This spring functioning to regulate the direction of rotation only. If pegasnya too little, then the rotation will occur in both directions, up to two-way if it can not be used.
8. If it still can be cut safely deh ...
9. Ga can be cut if forced to find another printer kanibalan form

The steps above can be used on the printer type MP 140, MP 150, MP160, IP 1200, IP1300, IP 1700, IP 1880, and IP 1980

Read More

How to Service Error 5100 on Canon printer

Service Error 5100 is often experienced when the new printer is turned on, or when the printer is preparing to print. This is because the cartridge carriage can not move, or movement is obstructed by "something".

This method is used for all types of printers Canon IP1200, IP1300, IP1500, IP1600, IP1700, iP1800, IP1900, MP140, MP150, MP160, MP180
Try to open the hood of your printer. then try to turn it on. Usually when the carriage catrigde are in the right position (cartridge carriage parking lot), this error will appear. Turn off your printer and slide the carriage to the middle or the left. Notice at the end of the right, there is a component assy (ga know what it's called) just where the printer is ink nyedot or head cleaning. In the IP series is usually white, and black on the MP series.

Pay attention to the four aces this place is connected to the printer body, as this usually dry or grease / lubricant discharged. If you have any grease / lubricant, give this as a lubricant in the fourth. Do not use oil lubricants yes, try to use grease. Or if not averaged only remaining grease as such.

But sometimes this does not work, especially if as has been worn, consumed by the printer body. If you have this I usually play a cannibal, alias replacing the part of other printers (which already ga used) to fix it.

In addition to wear and dry lubricants, usually by her loose. and also sometimes there is a foreign object fun in and prop. Clean up this foreign body. Sometimes the use of cleaning or deep cleaning that is too often also can accelerate this damage. this is because the ink will be spilled and soaked as such. So try cleaning the ink with a tissue.

Good luck .......!!!!!

Read More